Get matched with top pressure washers in Patterson, MO

It is possible to wash your own roof, but we don’t recommend it. First, getting up on any roof is dangerous without proper safety equipment, especially if wetting a metal roof and making the surface slick. Additionally, it’s easy to damage your roof or force water between roof seams if you use a power washer, which can lead to property damage. Hiring a professional roof cleaner will save you time, keep you safe, and ensure that your roof looks new again without damaging it in the process. Plus, roof cleaning is a relatively affordable home improvement project.

Depending on the amount of experience you have with power washing or pressure washing, hiring a professional is likely a better option. Using a pressure washer requires a bit of know-how to avoid damaging siding, trim, roofing shingles, and even the seals on your windows. Holding the pressure washer too close to the material you’re cleaning can cause damage to the surface. You can wash your home’s exteriors with a garden hose, but high-pressure cleaning should be done by professionals. 

For pressure washing a driveway, a PSI (pounds per square inch) between 2,000 and 3,000 is recommended for both concrete and asphalt surfaces. A pressure of 3,000 PSI is ideal for deep cleaning without causing damage, effectively removing debris, dirt stains, and even oil spills. If your pressure washer has a lower PSI rating, you can still use it, but the cleaning process will take longer. For a more efficient and even clean, consider using a surface cleaner attachment.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.