Top-rated well and pump technicians.

Best well and pump technicians near Walker, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Walker, MN?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Walker - Updated Nov 2026

Steamboat Plumbing
5.0(
4
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Walker, MN and surrounding areas

In business since 2024

Free estimates

Credit card accepted

"Steamboat Plumbing's owner Luke Ewert exceeded my expectations! He was incredibly helpful, friendly, and professional, taking extra time to ensure I understood my new water softener's operation, including navigating cycles and settings. He also walked me through shutting down my cabin's plumbing system for the fall, allowing me to video record the process. Luke's clear explanations, patience, and personal touch made the experience seamless. His dedication to customers is impressive. I appreciated the opportunity to chat with him about his background and family, which added a nice touch to the service. I highly recommend Steamboat Plumbing and Luke Ewert for exceptional service, expertise, and customer care. I will definitely use Steamboat Plumbing again in the future!"
Response time1 day
Recommended by75%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Walker, MN and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps FAQs, answered by experts

Signs that your well is dry include a decrease in water pressure, strange odors coming from faucets, cloudy, bubbly, or discolored water, and water that’s warmer than normal. Signs that your well pump is bad are similar, but you may also notice higher-than-average electric bills, strange clicking sounds, and faucets that spit or sputter.

Yes, it is possible to drill a well by hand, but it calls for a good deal of physical labor. Drilling a well by hand is best suited for softer soil, and it may not be possible through rockier terrain. For wider and deeper holes, companies with professional equipment make the job much easier.

The cost to replace a well-pump motor will depend on the size, but this repair is often as costly as installing a new pump. Generally, a well-pump replacement will cost between $950 and $2,650, with an average of $1,800. Other factors like pump type and pipework will impact your final cost.

If your well pump gets stuck in its casing, you may be able to free it loose by gently wiggling the line or by vibrations from tapping the line with a hammer. However, if your pump is stuck in a buildup of minerals around the casing, you’ll probably have to call in a well pump contractor to get it out. They’ll likely use a muriatic acid solution—a strong, corrosive acid—to break down the minerals and free the pump loose. 

To avoid a stuck pump in the future, experts recommend a professional well cleaning once every 10 years. 

Yes, you can shock a well yourself, but it can be dangerous if you don’t know what you’re doing. We recommend calling a pro, but if you decide to do it yourself, make sure to follow proper safety precautions. This means wearing the correct safety gear, such as rubber gloves, goggles, and boots. You should also mix the chlorine solution in an open area with plenty of ventilation. Also, make sure not to drink or use the water for a few days afterward, until you’ve flushed the system and retested the water.

The Walker, MN homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.