Top-rated concrete driveway pros.

Get matched with top concrete driveway pros in Appleton, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete driveway service project in Appleton, MN?

Select your specific project to find the pro for you.

Find Concrete driveway pros in Appleton

Avatar for American Waterworks
American Waterworks
4.5(
171
)
Concrete Flatwork - Repair & ResurfaceConcrete Flatwork - Repair & Resurface- For Business

Serving Appleton, MN and surrounding areas

Approved

In business since 1989

Free estimates

Warranties offered

"They did great. The entire surface was level and free from tripping hazards. It is important to have them seal the cracks because there will be water from snow melt and the concrete will move. This will get you the 5 yr warrantee just in case."
Another Sinking Floor
Dirt Crawlspace in Elk Mound, WI
Concrete stoop had sunk over 6 inches
Foundation Failure Signs
Increased Efficiency of Crawlspace in Elk Mound

+156

Response time4 hrs
636 neighbors recently requested a quote
Recommended by91%of homeowners
Avatar for Simstone Concrete Works Inc.
Simstone Concrete Works Inc.
3.7(
19
)
Concrete Driveways & Floors - InstallConcrete Driveways & Floors - Install- For BusinessConcrete Driveways - Install+4 more

Serving Appleton, MN and surrounding areas

In business since 1998

Credit card accepted

"Initial estimate was for the concrete tear out only. Emailed Ross for a side visit. He came the same day. Quoted $1700 ($1200 for 4 inch). After the tear out was done, I asked him to quote the class five preparation. We agreed on $1350 and the work was done the next day. Everything was done on time. He left the work side and street clean. Everything is ready for me to put the pavers down. Very nice to work with. Good job."
Additional Photos
Additional Photos
Additional Photos
Simstone Concrete Works Inc.
Simstone Concrete Works Inc.

+4

Recommended by75%of homeowners
Avatar for Vick's Sealcoating
Vick's Sealcoating
3.7(
9
)
Asphalt Paving - Install

Serving Appleton, MN and surrounding areas

In business since 2012

Free estimates

"Mr. Vick was very professional and friendly. We were impressed with the quality of his job and how it only took him one hour to finish the it. We would recommend him to anyone that needs their driveway or parking lot seal-coated.
"
Additional Photos
Additional Photos
Additional Photos
Recommended by75%of homeowners
Graystone Concrete & Masonry, LLC
New to Angi
Concrete Driveways & Floors - Install- For BusinessConcrete Flatwork - Repair & Resurface- For BusinessConcrete Patios, Walks & Steps- Install

Serving Appleton, MN and surrounding areas

In business since 2009

Free estimates

GrayStone Concrete & Masonry, LLC, is your 1st and finest choice in concrete and masonry, all right here in our community. GrayStone Concrete and Masonry, LLC, produces elegant concrete and masonry work. Producing the ultimate in quality craftsmanship, with pride in doing great work, we care for your place and your project, as if it was our own. We are your one-stop shop serving the complete project, even aspects not noticeable -- we allow the whole to be completed right when it should be. Rest assured and everything is good with GrayStone Concrete & Masonry, LLC. We are perfectionists and all of our work is guaranteed. Call now.

Showing 1-10 of 12
Concrete Driveways questions, answered by experts

On average, pressure washing a house can take anywhere from 30 minutes to three hours. The time frame to pressure wash or power wash your home, fence, or other property depends on the size of the project and the complexity and accessibility of the areas that need cleaning. Part of the time required to complete the job includes setup and removal of equipment needed. A two-story house with a steep roof may require working from scaffolding or a ladder, likely adding to the time required to finish the project. 

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.

You can hire a landscaper to clean up your asphalt driveway or make minor repairs. You can also hire a company that specializes in asphalt driveway installation and repair. For cleaning jobs, most landscapers charge by the hour. Pressure washing a driveway costs between $100 to $350, but spot treatments and refilling damaged asphalt will cost extra.

Yes, baking soda and vinegar can remove rust from concrete. Vinegar is acidic and can remove rust stains from concrete on its own. Adding baking soda may increase abrasiveness, which could help loosen some of the stain even more when scrubbing the stain. However, a stiff-bristled brush can do the same. 

Periodic sealing and cleaning to maintain appearance and integrity.

The Appleton, MN homeowners’ guide to concrete driveway services

From average costs to expert advice, get all the answers you need to get your job done.