Question 1

Can a shut-off valve go bad?

Accepted Answer

•

Shut-off valves, like any other piece of metal hardware, can corrode, age, get worn down, and eventually break or rust into place. Occasionally spray your shut-off valve with WD-40 to stall it from rusting. If it really gets stuck, a wrench and WD-40 will usually do the trick, but you will need to call a plumber if it’s completely unmovable.

Question 2

How are propane tanks professionally installed?

Accepted Answer

•

Propane tanks are professionally installed by assessing the site for safety, placing it correctly, connecting it securely, and ensuring compliance with safety regulations.

Question 3

How much does it cost to move a gas line?

Accepted Answer

•

Renovation projects that require moving a gas-powered appliance may also require moving the gas line that supplies it. The cost to move a gas line falls between $375 and $750 and will depend on how far the line needs to be moved, the cost of the permits, and how much excavation is needed, along with other factors.

Question 4

How long does it take to install a gas line?

Accepted Answer

•

Installing a gas line is no simple task. From start to finish, you’re looking at anywhere from six to 12 weeks to acquire the correct permits, dig a trench, and connect your appliances. Naturally, the longer the gas line, the longer it will take to complete. If your plumber needs to hire additional contractors to dig trenches and navigate around or remove obstacles, this could put you at the longer end of the timeframe.

Once the land is prepped and licenses acquired, installing the actual line may only take a few days to a few weeks, weather permitting.

Question 5

Why does pipe size matter?

Accepted Answer

•

Having the right size pipe ensures proper drainage and helps protect against clogs and other plumbing problems. A pipe that's too small will take longer to drain, which can result in backups. And solids can build up in pipes that are too large. Choosing a pipe with the appropriate volume also means it will be able to handle water pressure, which is the force behind the water.