Top-rated welders.

Best welders near Onsted, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your welding project in Onsted, MI?

Select your specific project to find the pro for you.

Top-Rated Welders in Onsted - Updated Nov 2026

Wellman Welding LLC.
5.0(
1
)
Metal Structure or Object - Create CustomMetal Structure or Object - Weld or CutSheet Metal and Ornamental Metal - Fabricate+2 more

Serving Onsted, MI and surrounding areas

Approved

In business since 2024

Free estimates

Emergency services offered

"Wellman Welding made a custom wrought iron railing for me, and did the most phenomenal job! It is so impressive and gorgeous! The owner of the company, Destin, Is timely and extremely respectful and communicates very well. I am beyond thrilled with his work, and will definitely hire him in the future."
Showing 1-10 of 37
Welding FAQs, answered by experts

It will likely take an experienced pro less than an hour to install a ground rod, which is another reason why letting them handle the job is such a good idea. Safety concerns aside, it would likely take you much longer to install a ground rod if you decided to take this one as a DIY job.

This all depends on the tools you have on hand and whether you’re trying to cut a straight line or shapes. 

The best tool to use for straight lines is either a circular saw or table saw. When cutting shapes, a jigsaw will be the easiest and most precise tool to use. 

Cutting rectangular ductwork requires careful measurements and the right technique. Use a measuring tape and pencil to mark the cutting lines accurately. Tin snips are excellent for straight cuts on smaller ducts. For more extensive or thicker rectangular ducts, a reciprocating saw with a metal-cutting blade is effective. 

Ensure the duct is well-supported and secure while cutting to prevent wobbling and maintain precision. After cutting, use a metal file to smooth any sharp edges, ensuring safety during installation. 

Since water heaters are primarily made of metal, they’re commonly accepted by scrap yards and collectors. Don’t expect to fetch a high price, though—water heaters are mostly steel and aluminum, which aren’t high-value metals. Some components are made of more valuable metals, like brass and copper, but they’re a small portion of the heater and won’t affect the price much.

While a high-speed circular saw will cut through metal, and even cut through multiple sheets at once, the fast-spinning saw blades create a lot of heat. This heat can damage paint and other protective coatings, leading to serious problems like rust over time. The cost to paint a metal roof again to avoid this damage is typically an additional $0.50 to $1 per square foot.

The Onsted, MI homeowners’ guide to welding services

From average costs to expert advice, get all the answers you need to get your job done.