Get matched with top concrete driveway pros in Copemish, MI

Pressure washing your home or fence can make a major difference in the appearance and may even help extend the life of the structure you’re cleaning. Some of the most common areas that people pressure wash around their property include:

• Driveway: $100–$250

• Patio: $100–$200

• Fence: $150–$300

• Gutters: $50–$150

• Roof: $450–$700

• Siding: $150–$1,400

• One-story house: $150–$750

• Two-story house: $400–$1,400

• Three-story house: $700–$1,800

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.