Get matched with top stucco pros in Otis, ME

Solid, unpainted stucco shouldn’t suffer damage from dots of glue used for this task. If the stucco is dirty, you may notice slight marks when you heat and peel the glue away, but these aren’t permanent.

However, not all stucco walls are solid stucco. Some are “faux” stucco with a foam backing. This kind of stucco veneer is more susceptible to damage, including damage from hot glue. We don’t suggest attaching anything to these kinds of stucco walls, so make sure you check the stucco type before starting this project.

To repair damaged exterior stucco, you’ll first remove all loose and crumbling material from the damaged area. You then need to thoroughly clean the area and dampen it to ensure proper bonding. After that, you’ll apply a bonding agent to the repair area, then apply new stucco in layers, allowing for curing time between each layer. The final coat should be textured to match the surrounding stucco pattern as closely as possible. Once fully cured, the repaired area can be painted to match the rest of the wall if needed.

Failing to repair damaged stucco can lead to significant problems. Cracks can grow and deepen, allowing water and moisture to get behind the stucco. This moisture intrusion can cause water damage, structural issues, and mold or mildew growth. Delaying repairs will likely cost more in the long run as the damage worsens, so it's best to repair your stucco as soon as you notice any signs of damage, such as cracks, holes, or discoloration.

When cleaning stucco siding, it is recommended to use a pressure washer with a psi (pounds per square inch) between 1,500 and 2,000. This range provides sufficient power to remove dirt and grime without causing damage to the stucco surface. It's important to avoid using excessive psi as it can chip or crack the stucco. 

Using a wider spray nozzle and keeping a safe distance of about seven to 10 feet from the siding helps ensure a gentle and effective cleaning process. Always follow the manufacturer's guidelines and adjust the psi accordingly based on the condition of your stucco and the specific requirements of your pressure washer.