Get matched with top bathtub restoration pros in Hackberry, LA

Refinishing a bathtub takes about two to four hours, but let the surface set for another 24 to 48 hours before using it again. Once it's set, your tub should last for 10 years or more. Ventilating the bathroom during this time is key for safety. In comparison, it takes about four hours to install a new bathtub.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

For a standard-sized bathtub with minor damage, it takes approximately 3 to 5 hours to refinish. It might take a bit longer if your bathtub refinishing contractor needs to fill in significant cracks or gouges. This is the same if you have a specialty tub, like an oversized bathtub—you can expect your pro to take a bit on the longer side.

There are a few signs, both obvious and not so obvious, that it's time to refinish your bathtub. While some of these signs aren't an urgent problem, others could lead to significant damage if left untreated. Signs you should look out for include:

• Rust stains, which signal the tub's enamel or surface sealer is deteriorating 

• Small chips, which can grow into larger chunks and can lead to rusting

• Discoloration, which doesn't lead to a more significant problem but can be unsightly 

• Dirty surfaces, which means that the tub glaze is breaking down and allowing dirt to seep below the coating