Get matched with top masons in Forest Hill, LA

No, it’s not recommended to attach shutters to brick without drilling. Brick is dense and built to last, so adhesives and shortcut methods don’t usually cut it. Even heavy-duty glue struggles to hold up over time—especially against wind, moisture, and temperature changes. Most no-drill options are made for materials like vinyl or wood, not solid masonry. Skipping the drill might seem easier, but it puts your shutters—and anything below them—at risk. For a secure, lasting install, drilling is the way to go. It takes more effort up front, but the result is safer and more reliable.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

Yes, you can do German schmear on stone. You can account for the more textured and rough surface of stone by using a large paintbrush instead of a putty knife. A brush allows you to drag mortar across the stone to get it into all the cracks and crevices. However, a brush will cover more of the surface, so you may need a wet sponge to scrub excess mortar and expose more of your stone.

You should use cement for a chimney crown. The purpose of the chimney crown is to protect the mortar below from water damage and the effects of weather. For this reason, chimney crowns should only be made using cement. When repairing a crown, use caulks and sealants designed for cement repair rather than mortar repair.