Get matched with top dishwasher installation pros in Lockport, IL

Depending on your available time and skillset, there are some aspects of dishwasher repair you can DIY. Remember that dishwashers use water and electricity, which can cause potentially hazardous situations. However, there are some things you can do to reduce your overall repair cost, such as:

• Cleaning the spray arm

• Unclogging the float

• Replacing the door gasket

• Cleaning the door filter

• Adjusting the door latch

Dishwashers should be cleaned a minimum of once every 3 months, but really it should be done monthly. This is to prevent germ buildup and will help keep your machine running smoothly. Dishwasher maintenance isn’t too difficult, you’ll simply clean the filter, wipe down the spray arms with vinegar or rubbing alcohol, and run the cycle on empty. If there is any debris, you can remove it with a small metal pick. Do not use wood as the tip can break off inside the machine.

A clogged air gap can cause a dishwasher not to drain. There are, however, other potential issues that can lead to improper drainage. For example, if you have attached the air gap to a garbage disposal and forgotten to remove the knockout plug, wastewater may backflow into the dishwasher. Check that the air gap is installed properly, and then look for clogs in the air gap and dishwasher filters. 

Some signs that your dishwasher is going out include:

• The door no longer latches 

• Dishes are still dirty after a cycle 

• Dishes are cold after a cycle 

• Rust inside or outside the unit 

• Cracks inside the dishwasher tub

• Water collecting at the bottom or outside the unit

If your dishwasher is not energy-efficient or is older than 10 years, you should also consider replacing it. Repairing an older model may be more expensive than replacing it with something newer and more energy- or water-efficient.