Top-rated well and pump technicians.

Get matched with top well and pump technicians in Clinton, IL

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Clinton, IL?

Select your specific project to find the pro for you.

Find Well and pump technicians in Clinton

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Clinton, IL and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Clinton, IL and surrounding areas

In business since 1971

Credit card accepted

"Rather than fix the issue the first 2 calls, more refrigerant was pumped into the system. This cost me $75 for each call plus the cost of the refrigerant. The 3rd time, they fixed a valve and refilled the refrigerant and I am monitoring to see if this really fixed the problem. So I am out $225 for service calls fro the same problem and the cost of the refrigerant. I think they take this approach intentionally."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps questions, answered by experts

Ideally, you should conduct a mechanical inspection and a bacterial or well water inspection yearly. While you might be able to push it off to every other year, it’s best to have peace of mind, especially when it comes to something that you use so frequently. 

If you experience repeated gastrointestinal illness in the household, it's important to test the well water more regularly for quality and cleanliness to check for bacteria.

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

Yes, professionals can replace worn-out motors to restore efficient airflow.

The cost to fix low water pressure heavily depends on the cause of the problem. In some cases, all you need to do is open a valve, which won't cost you anything. However, plumbing repairs cost an average of $325, so if you have a broken pipe or other plumbing problems, you might pay something close to that figure, or more, depending on the issue.

There are many reasons you may want to extend the depth of an existing well or drill a new, deeper well on your property. A deeper well can tap cleaner water sources—shallow water may contain more contaminants. With a deeper well, you’ll also have an easier time reaching the water table depth (the level at which underground water is found) and can get past tricky soil conditions. 

Plus, if your local building code requires a minimum well depth for safety and environmental standards, you’ll meet the code by digging a deeper well in the first place.

The Clinton, IL homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.