Get matched with top masons in Bridgeport, IL

Cutting stone comes with a number of safety hazards. First and foremost, if you’re not comfortable with the equipment required to cut stone, including blades and grinders, you could easily injure yourself. The heavy machinery also poses a risk to your ears if you don’t wear proper ear protection; similarly, you need to wear eye protection to keep debris from irritating your eyes.

However, the biggest risk from cutting stone comes from the stone dust. When breathed in, stone dust can be a huge hazard to your lungs. Always wear a face mask when cutting stone to prevent inhaling stone dust, and thoroughly clean the work area when you are finished.

To avoid injury, we recommend hiring a stone-cutting professional, rather than attempting this job yourself.

Modern brick homes have a brick facade over standard framing and sheathing, so the brick offers minimal added structural stability. A home with traditional brick construction is more durable than a stick-built home, as the double-layer brick walls and rebar resist higher lateral wind loads and support heavier loads up top, as well.

Solid brick structures can last a century or more, potentially 100 to 150 years with proper maintenance like tuckpointing. Without major repairs, classic red bricks may last 20 to 40 years. Brick veneer siding is also a long-lasting material, with a lifespan ranging from 50 to 100 years, provided it is properly installed and maintained. To maintain brick veneer, you should scrub it annually with a special detergent and a soft-bristled broom. It's also important to inspect the bricks and mortar regularly and hire a masonry contractor for any necessary repairs, such as fixing worn mortar or bowing bricks.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.