Get matched with top stucco pros in Kingston, ID

Depending on the amount of damage, a stucco repair professional can repair your stucco siding in four to 12 hours. If you only have a few small cracks, that repair could take as little as one to two hours to repair. In contrast, if you have an extensive fix, like foundation or chimney repair, you can expect the process to take a bit longer. Always discuss your project expectations with your stucco repair expert.

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

Stucco is very challenging to DIY, so it’s always best to leave the work to professional stucco contractors. The same recommendation applies to painting a stucco house, which should be left in the reliable hands of a professional exterior painter. Inexperienced DIYers can make several critical mistakes during stucco application, such as:

• Failing to apply sufficiently thick layers for longevity and water resistance

• Uneven application

• Uneven texture across the exterior

• Mixing the stucco improperly, leaving a weak structure

• Failing to texture properly in between coats, leading to cracking and chipping

To repair damaged exterior stucco, you’ll first remove all loose and crumbling material from the damaged area. You then need to thoroughly clean the area and dampen it to ensure proper bonding. After that, you’ll apply a bonding agent to the repair area, then apply new stucco in layers, allowing for curing time between each layer. The final coat should be textured to match the surrounding stucco pattern as closely as possible. Once fully cured, the repaired area can be painted to match the rest of the wall if needed.