Get matched with top cabinet makers in Georgetown, ID

Solid wood is the most common material for cabinet bases. It’s a popular choice because it’s durable and will hold up over time. Oak, maple, cherry, hickory, and pine are all types of solid wood that can be used to build cabinet bases. Other options include plywood, medium-density fiberboard, and other types of manufactured lumber, but they need to be sealed properly to avoid swelling, separating, and delamination from moisture.

The 1/3 rule is a design guideline used by interior designers and cabinet installers to select appropriately sized pulls for cabinets and drawers. The rule suggests that for a balanced and cohesive look, a cabinet pull should be approximately one-third the height of the cabinet door or one-third the width of the drawer face. This guideline helps create a symmetrical appearance because the human eye tends to follow the length of the pull across the cabinet face.

While the 1/3 rule is a helpful starting point, it is not the only option. If a measurement falls between available pull sizes, it's generally best to size up. For an ultra-contemporary aesthetic, you can also opt for full-width pulls that span the entire drawer.

Most cabinetry made for a garage will have special coatings and finishes built to withstand extreme heat and cold, moisture, pest damage, rusting, and dry rot. However, many homeowners have put their old kitchen cabinets in the garage, added a couple of fresh coats of paint, and use them for a while without too much wear and tear.

Yes, there are some options for pre-built inset cabinets—and RTA ones, too—but the selection can be somewhat limited. Many homeowners who decide on inset cabinets choose to have them custom made.