Top-rated deck cleaning pros.

Best deck cleaning pros near Pahoa, HI

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Pahoa, HI?

Select your specific project to find the pro for you.

Top-Rated Deck cleaning pros in Pahoa - Updated Nov 2026

Avatar for Concrete Performance HI
Concrete Performance HI
4.3(
2
)
Deck, Fence, Patio or Porch - Clean and Seal

Serving Pahoa, HI and surrounding areas

In business since 2001

Free estimates

"They were a little rushed, because of a late start due to car trouble and this seemed to affect their efficiency. Some of the windows downstairs were not cleaned as promised."
Response time9 hrs
Response rate86%
Recommended by100%of homeowners
MonellEnterprises
5.0(
1
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Pahoa, HI and surrounding areas

In business since 1995

Free estimates

Warranties offered

"Excellent job on our bathroom improvement. Priced right for the job. Thorough and complete from start to finish. Alex Monell was professional and knew what he was doing. I would definitely call him back for other projects and strongly recommend him. Thank you."
Recommended by100%of homeowners
Deck Cleaning FAQs, answered by experts

PVC decking can get slippery when wet because it’s made from plastic. However, composite and wood decking can also be slippery when wet. It’s best to wear shoes with grippy soles when walking on a wet deck, no matter the material, and to be extra cautious not to slip and fall down.

Footings for ground-level decks need to be at least 12 inches deep, and some areas require them to be even deeper. A standard range for deck footings is anywhere from 12 to 48 inches. The minimum footing depth is determined by an area’s frost line and soil conditions. If you’re unsure how deep to install deck footings, check local building codes to find the minimum footing depth in your area. 

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

The average cost to professionally clean or pressure wash a deck is around $150, with prices typically ranging from $100 to $600. Several factors influence the final price, including the deck's size, material, condition, and how long it has been since its last cleaning. For a smaller deck of about 300 square feet, you might pay around $100. For a larger deck of 1,000 square feet or more, the cost could be closer to $300 to $400. Decks that are very dirty or haven't been cleaned in years may require more time and special detergents, which will increase the price. The deck's material also plays a role. Wood decks often cost more to clean because they require a gentle power washing technique to avoid damage. Composite decks are typically less expensive to clean, and cleaning a metal deck may cost around $100.

You can nail or screw composite decking, but 3-inch decking screws are the better fastener choice. Unlike nails, decking screws won’t back out of the composite material over time. There’s also little danger of splitting composite material when driving screws, so you don’t need to pre-drill holes unless otherwise recommended by your decking manufacturer.

The Pahoa, HI homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.