Top-rated carpenters.

Get matched with top carpenters in Reidsville, GA

Enter your zip and get matched with up to 5 pros

Need a pro for your carpentry project in Reidsville, GA?

Select your specific project to find the pro for you.

Find Carpenters in Reidsville

Avatar for Espinoza Exteriors LLC
Espinoza Exteriors LLC
5.0(
8
)
Deck or Porch - RepairGazebo or Freestanding Porch - Repair

Serving Reidsville, GA and surrounding areas

Approved

In business since 2012

Free estimates

Offers commercial services

"Excellent craftsmanship, can definitely say Mr. Espinoza and his crew go above and beyond expectations down to the last detail. Will be recontacting in the future again thatâ s for sure!!"
Response time2 days
Response rate89%
1 neighbors recently requested a quote
Avatar for YOURBROTHERSLLC
YOURBROTHERSLLC
New to Angi
Furniture - Build Custom

Serving Reidsville, GA and surrounding areas

Approved

Hi. My Name is William, but you can call me Bill. I’m a fair, honest, dependable guy that’s hard working and reliable. I won’t accept a job Im not confident in finishing, I won’t scam anyone. I just ask to be treated fairly and equitably.

Avatar for Doug's Pinestraw
Doug's Pinestraw
4.8(
51
)
Deck or Porch - Repair

Serving Reidsville, GA and surrounding areas

In business since 2006

Free estimates

Emergency services offered

"Extremely satisfied with entire transaction. Doug responded almost immediately to my request for a quote. Gave quote over the phone and scheduled day/time to come out. Three man crew arrived right on time and wasted no time going to work. Did not rush doing the job and end result was, fence looked like new. Will definitely use Doug for other projects in the future."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+106

Recommended by94%of homeowners
...
Showing 1-10 of 190
Carpentry questions, answered by experts

In framing, studs are placed at 16-inch intervals to coincide with the typical spacing of wall materials such as drywall or plywood. This spacing is called "on-center" and is necessary for maintaining structural stability and efficient use of materials. The 16-inch spacing also helps to distribute the weight evenly across the building's structure. For those looking to cut material costs and improve energy efficiency, 24-inch stud spacing can be employed through a method called "advanced framing". This requires careful planning and adherence to local building codes to ensure structural integrity.

Yes, walls on the top floor can be load-bearing if stacked on the floor’s foundation.

An A-frame home can be cheaper to build than a traditional house, but that is not always a given. Prices can be fairly similar in some cases, depending on the location, design, and necessary site preparation. Costs for an A-frame typically run between $100 to $200 per square foot, which is comparable to the cost of a traditional home. The cost of an A-frame can come in under those numbers if you opt for a prefabricated kit.

One of the most common house framing basics for decades has been using wood for the framing work. However, some framing contractors now suggest using steel frames. Steel is lightweight, resistant to fire, and resistant to moisture, all of which are areas where wood framing could cause problems. However, steel framing is more expensive than wood and limits your ability to insulate the home.

A cross brace for a fence gate should stretch from the top corner of the gate’s hinge side to the bottom corner of its latch side at a 45-degree angle to the bottom of the gate. This positioning distributes the bulk of the gate’s weight to the base of the post, taking pressure off the top hinge.

The Reidsville, GA homeowners’ guide to carpentry services

From average costs to expert advice, get all the answers you need to get your job done.