Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in Burlington, CO

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in Burlington, CO?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in Burlington

Deck Maintenance questions, answered by experts

Yes, Ipe is more expensive than Trex decking—both in terms of materials and installation (plus, Ipe trees are endangered). On average, Ipe decking costs $10 to $25 per square foot, while Trex decking costs $5 to $12 per square foot. Because Ipe is harder to work with, the price of installation is higher, too. For Ipe decking, you’ll pay between $20 and $45 per square foot for labor. However, with Trex decking, the labor costs range from $8 to $22 per square foot.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

You typically don’t need a railing and handrails on a deck that’s less than 30 inches from the ground. However, consider adding them regardless. Railings provide additional safety for you and your guests who use your deck—plus, railings give the deck a more finished look than it would have without them.

Yes, deck pier blocks can be used as an alternative to traditional deck footings, especially for smaller or low-to-the-ground decks. Unlike poured concrete and buried post footings, deck blocks do not require digging or pouring. However, their use is dependent on local building codes. Some areas, particularly those prone to high winds, earthquakes, or hurricanes, may not permit the use of deck pier blocks. It is essential to consult your local building codes before choosing them for your deck project.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

The Burlington, CO homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.