Best concrete driveway pros near Fresno, CA

The ideal PSI (pounds per square inch) for a pressure washer depends on the surface you are cleaning. For general home use, a pressure washer with a range of 2,000 to 3,000 PSI is recommended and powerful enough for most residential projects.

The specific PSI you should use varies by task:

• High-Pressure Tasks (2,500-3,000 PSI): Tough materials like concrete, stone, masonry, and brick can handle higher pressures. This is suitable for removing stubborn stains from driveways or cleaning graffiti.

• Low-Pressure Tasks (around 600-1,300 PSI): Softer surfaces require a gentler touch to avoid damage. Use a low PSI setting for cleaning wood decks (especially softwoods like pine and cedar), vinyl siding, outdoor furniture, and stucco.

For best results, choose the right nozzle for your surface, such as a 15-degree nozzle for siding or a surface cleaner attachment for driveways. Using an extendable wand can also make the work easier and more ergonomic.

On average, pressure washing a house can take anywhere from 30 minutes to three hours. The time frame to pressure wash or power wash your home, fence, or other property depends on the size of the project and the complexity and accessibility of the areas that need cleaning. Part of the time required to complete the job includes setup and removal of equipment needed. A two-story house with a steep roof may require working from scaffolding or a ladder, likely adding to the time required to finish the project. 

You can put a gentle cleaner such as distilled white vinegar, dish soap, or a degreaser in your pressure washer in a detergent injector. The attachment will mix your detergent with the water and spray it out. If you have stubborn stains on your driveway, a gentle cleaner in the attachment can help dissolve and remove those stains. Rinse the area with the pressure washer.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.