Get matched with top toilet pros in Earlimart, CA

To keep your toilet in good working order, replace the toilet fill valve every five years. Toilets get quite a workout, so while toilet maintenance may not be on top of your to-do list, it’s essential to keep up with it to ensure your toilet is in good working order and ready when needed.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

Yes, you should screw your flange to the subfloor, including cement. The best way to get this done is to predrill holes into the concrete using a hammer drill and a ¼-inch concrete bit. Be careful when you’re ready to bolt your flange down, as you can accidentally crack it. You can avoid this issue by not installing the screws too deep. Or, you can opt for a flange with a stainless steel ring so you don’t have to worry about cracking the plastic.

The most common toilet repair is dealing with clogs, followed closely by replacing a worn-out flapper. While clogs can happen anytime in any toilet, they most commonly occur with older toilets that have smaller diameter clearances and often empty into smaller diameter sewer connections. Because toilet flappers only last a few years, they are next in line for the most common toilet failures.