Get matched with top water heater pros in Viola, AR

Several signs indicate your water heater may be failing or in need of replacement. Key indicators include:

• Age: A water heater older than ten years is approaching the end of its typical lifespan.

• Water Quality: If you notice rusty or discolored water from your hot water faucets, or a foul odor similar to rotten eggs or sulfur, it can signal internal corrosion.

• Unusual Noises: Banging, rumbling, or popping sounds from the tank often mean sediment has built up, causing the unit to overheat.

• Leaks: Any water pooling around the base of the tank or visible leaks are clear signs of failure.

• Performance Issues: A decline in performance, such as water not getting hot enough, taking longer to heat up, low water pressure, or decreased efficiency, suggests the unit is struggling.

• Visible Damage: Obvious rust and corrosion on the exterior of the tank can indicate a more serious internal problem.

While these signs often point to replacement, some issues may be fixable. It's best to consult a professional plumber to diagnose the problem before investing in a new unit.

Every city and state will have its own set of installation codes and laws. Some won’t require you to obtain a permit before replacing your water heater, though we recommend you do, regardless of the local codes. On the other hand, some cities and states might require secondary permits for plumbing and electrical work related to the installation. Check with a local water heater installation company and local building codes to confirm which permits are required and what the specific laws are.

It is very difficult and dangerous to install your own water heater, so we strongly recommend against tackling this as a DIY project. Not only will you need to wire your water heater, but you’ll also need to connect plumbing to the intake and outlet. Sweating copper pipes and connecting wiring properly are skills most DIYers don’t have, and even if you do feel confident you can do it, working with water and electricity always leaves the potential for electrocution. Hiring a local water heater installer is well worth the investment.

The time it takes to install or replace a water heater depends on the type of heater and the complexity of the job. A professional can typically replace a standard tank-style water heater in one to three hours. However, if the work area is tight, such as a small closet or crawl space, the job could take four to five hours. Replacing an existing tankless unit takes about two to three hours, while upgrading from a tank-style to a tankless water heater is more complex and can take four to six hours. The project will take longer if you are switching fuel sources, such as installing a gas heater which can add about an hour to the timeline, or if the unit needs to be relocated.