Best concrete resurfacing pros near Piggott, AR

Concrete resurfacing is the process of applying a new, thin layer of concrete over an existing concrete slab to enhance its appearance and durability. The terms 'concrete resurfacing' and 'concrete overlay' are often used interchangeably, though the exact meaning can vary between contractors. Generally, both refer to applying a layer of pre-blended concrete, typically between 1/4-inch and 1-inch thick. Some contractors may use 'overlay' to describe a thicker application that adds structural integrity, while 'resurfacing' might refer to a thinner, more cosmetic layer. This process is a cost-effective alternative to completely replacing the concrete, as it uses significantly less material than pouring a new 4-inch slab. Resurfacing also provides an opportunity to add new colors or stamped textures. Other names for this process include concrete restoration, concrete refinishing, and concrete rejuvenation.

In almost all cases, yes, a damaged concrete driveway can be repaired, and the repair cost will be more affordable than a full replacement. Even major damage, like a sinking section of concrete, can be repaired by a professional using mudjacking or polyurethane concrete lifting and will average about half of the cost of a new driveway.

There’s no legal requirement that states that you need rebar in a concrete driveway, but since the slab will be supporting heavy vehicle loads, it’s always a good idea to pay a bit more for rebar reinforcement. Your driveway will be much more likely to crack if you don’t reinforce it with rebar. Driveways that need to support commercial vehicles or provide parking for multiple vehicles at once should always include rebar reinforcement. If you’re pouring concrete over asphalt or pouring concrete over an existing slab, you may not have enough depth for rebar, meaning an increased risk of cracking.

Concrete can crack from general wear, improper installation, or in response to uneven support from the soil underneath. Small, thin cracks on the surface of aging concrete are usually a result of normal wear and tear, while cracks on new concrete more likely indicate a problem with installation. Larger cracks or uneven steps can signify a much more severe issue. A concrete contractor should be able to diagnose the cause and repair concrete cracks for you.