Get matched with top sonic cleaning pros in Fordyce, AR

You may become so frustrated with the look of moss on your roof that you contemplate whether to clean or replace your roof. Fortunately, you don’t have to go as far as replacing it. After cleaning the moss, you can use a chemical solution to keep it away. For further protection, trim branches that overhang the roof, as fallen seed pods and leaves on the roof allow moisture to collect, encouraging moss growth. Consider adding zinc-coated flashing to the roof, too. As rain washes across the zinc, it leaves zinc particles behind that inhibit moss growth.

While it’s not completely necessary for them to operate properly, as the occasional rainfall can rinse away dirt and debris, manually cleaning solar panels from time to time can keep them operating more efficiently.

Dirt, debris, pollen, and bird droppings can collect on the surface of the panels. Depending on the amount of solar panels you have, this can add up over time, so set a regular maintenance schedule. Moreover, if you live in a climate with little to no rainfall, more debris can accumulate, causing inefficiencies that would be clear in your electricity bill. 

It may require stronger cleansers or chemicals, higher-pressure spray, or scrubbing to completely remove algae from a metal roof. Start with a mild cleanser; if that doesn’t work and you're comfortable doing so, use a stronger mix of ⅓ cup of laundry detergent, 1 quart of bleach, and 3 quarts of water to gently scrub the algae with a soft-bristled brush. If algae is present across large portions of your roof, doesn’t come off with gentle scrubbing and cleansers, or is in hard-to-reach areas, this may be a job better left to a pro.

Moss grows in dark areas of roofs, including in corners and gutters. If left alone, it can grow under roofing and cause permanent damage. Here’s how to remove moss from metal roofs: 

• Soak the moss to soften it

• Scrub it away with a soft-bristled brush, or pick it off with your hands (be sure to wear gloves)

• Use a moss remover that’s compatible with metal roofing, following the manufacturer’s directions

• Remove dead moss and rinse the roof thoroughly

• Prevent future moss growth by trimming branches, cleaning gutters, and attaching zinc strips to moss-prone areas