Get matched with top pool table assembly pros in Berryville, AR

A swimming pool pump has to have water in it to run properly. If the pump isn’t primed and tries to run when it’s dry, the components will overheat which can cause the pump to seize up and can even damage the PVC pipes that carry the water into and out of it. Essentially, running a pump that isn’t primed can lead to having to replace the entire pump.

The total time to install an inground pool typically ranges from 8 weeks to 4 months. This timeline can be influenced by several factors, including permitting, site preparation, and the construction process itself.

Key phases and their typical durations include:

• Permits: Obtaining necessary permits can take anywhere from two to six weeks.

• Excavation and Site Preparation: This phase takes about a week but can be extended by problematic soil, unexpected ground conditions, or the need to move underground utility lines.

• Construction: The actual build, including plumbing and electrical work, often takes one to two months. The pool material is a major factor here; a concrete pool needs about 30 days to cure, while installing a fiberglass or vinyl liner is much faster.

External factors can also cause significant delays:

• Contractor Availability: Spring and summer are busy seasons, and high demand can lead to long waitlists, potentially adding months to your start date. It is often recommended to start planning and getting estimates up to a year in advance.

• Other Delays: Weather, material shortages, complex designs, and other unforeseen challenges can extend the project timeline.

It's not ideal, and if your pool’s pH is seriously low (below 7), swimming can be dangerous until you raise it, potentially causing severe irritation and damage to the skin and eyes.

Keep in mind that low pH can also be responsible for damaging the pool itself. Acidic water can contribute to the cracking of your pool's liner, which may cost up to $2,500 to replace, making this an expensive fix.

Yes, a pool with a heater will lose more water. The heater warms the water, which increases the rate of evaporation. To minimize water loss from evaporation, you can install a pool cover and keep the pool covered when it is not in use.