Get matched with top concrete driveway pros in Sulligent, AL

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

If your garage floor is heavily soiled or stained, then it’s a good idea to powerwash it with a concrete cleaner before sealing. This process will remove dirt and debris to help the new sealer bond to the concrete properly, and it will also improve the look of your sealed garage floor. After power washing your floor, make sure you let the concrete dry completely before applying sealant, usually for 24 to 48 hours.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.

Yes, you can use a mixture of 1 tablespoon of bleach and a gallon of warm water to clean stubborn stains from brick. Do not use bleach without diluting it in water. Undiluted bleach may cause discoloration. You can use either Oxygen bleach such as OxiClean or chlorine bleach. Always wear protective gloves and eye protection when handling bleach.