Get matched with top pool table assembly pros in Fort Payne, AL

Yes, you should keep your pool pump running when adding salt, and leave it running for 24 to 48 hours. This will help circulate the salt to ensure even distribution. You will want to turn off your pool’s salt chlorine generator before adding salt and leave it off until it fully dissolves. Check your manufacturer’s instructions for steps specific to your saltwater pool maintenance.

Yes, small pool leaks are fixable with waterproof patches and sealants. It is always best to avoid draining a pool if you can, since doing so safely takes time, patience, and a whole lot of water to refill it. Larger pool leaks may require draining, but in this case, it's best to call in a professional.

Pool leaks most commonly occur at joints or where different materials meet. The most frequent leak spots include:

• The Pool Skimmer: Where the plastic skimmer meets the pool's liner or shell.

• The Pool Liner: Tears can develop in vinyl liners, especially those between 5 and 20 years old. Leaks also occur around the liner's edge.

• Fittings and Accessories: Areas around return lines, the main drain, and pool lights are common culprits.

• Pool Equipment: The pump, filter, and filter housing can also leak.

While leaks in underground pipes are less common, they can be costly to fix. It's usually best to check the more common spots before investigating the plumbing system.

Shipping container pools are prone to rust and corrosion over time, especially if you install a saltwater system. Though the interior of your pool should be lined, the outside is at risk. Luckily there are a few things you can do.

Elevate your pool or place it on a foundation to prevent moisture buildup along the bottom of the container. Apply a rust inhibitor or paint to protect the outside of your pool, and maintain the proper chlorine levels to reduce the rate of corrosion. Regularly inspect your pool for signs of corrosion, and take action when necessary.