Top-rated paving pros.

Get matched with top paving pros in Elmore, AL

Enter your zip and get matched with up to 5 pros

Need a pro for your paving service project in Elmore, AL?

Select your specific project to find the pro for you.

Find Paving pros in Elmore

Avatar for Roman Landscaping Services in GA, LLC
Roman Landscaping Services in GA, LLC
5.0(
22
)
Gravel or Loose Fill Paving - Install, Spread or ScrapeInterlocking Pavers for Patios, Walks & Steps - Install

Serving Elmore, AL and surrounding areas

In business since 2016

Free estimates

"The workers arrived promptly and began/started performing their duties and responsibilities. I was glad that the Project started a day earlier than expected! There were no deviations from the planed work; except the Contractor underestimated the amount of Sodding needed. Nonetheless, Mr. Omar Perez resolved the matter very quickly and amiably!! We were satisfied with the product and Services!"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+25

Recommended by100%of homeowners
Southern Striping, Seal Coating, and Asphalt Services
5.0(
5
)
Asphalt Paving - Install

Serving Elmore, AL and surrounding areas

In business since 1986

Free estimates

Credit card accepted

"Project: Seal Asphalt Steve Parker, of Southern Striping, Seal Coating & Asphalt Services, was very prompt in providing proposal and scheduling service. Project started on day promised, I was informed of all steps, project completed, well done. Very pleased with the work."
Response time4 days
Recommended by100%of homeowners
...
Showing 1-10 of 62
Paving Services questions, answered by experts

The recommended minimum amount for a paver base is 4 inches. From there, it depends on the kind of traffic the pavers will see and the current soil conditions. Two inches of paver base won’t create the amount of stability and support that pavers need to remain securely in place over time.

Chip seal layers gravel and a liquid bitumen one at a time on-site, while asphalt directly pours a pre-combined mixture. Asphalt must be sealed, but it will last up to four times as long as chip seal driveways. Aesthetically, chip seal has a natural, rustic look compared to the traditional asphalt slab.

Box fill refers to the maximum number of conductors that can be contained within a wiring enclosure box, as well as the total volume of the components. Determining the allowable number of conductors in a box requires adding up the number of conductors, clamps, support fittings, devices and equipment, and equipment grounding conductors to make sure you’re within the allowable volume.

The average cost of 1,500 square feet of asphalt ranges from about $10,500 to $22,500, depending on location, thickness, base material, and how accessible the job site is to crews and equipment. Keep in mind that your asphalt material cost may vary depending on its type, ranging from porous asphalt to heated blacktop. Standard asphalt costs $7 to $13 per square foot.

The answer to whether or not you need to get a permit before you start your driveway can vary widely based on local ordinances and the scope of your driveway ideas. In most urban and suburban areas, a permit is needed before building a new driveway to ensure that a homeowner is using safe materials and proper drainage practices while designing and constructing a new driveway. In some rural areas, a homeowner may not be required to apply for a permit. When building a new driveway on your own, always check with your local building department to see if you need to request a permit. When hiring a driveway contractor, verify that the right permits are being used before driveway construction begins.

The Elmore, AL homeowners’ guide to paving services

From average costs to expert advice, get all the answers you need to get your job done.