Get matched with top locksmiths in Chancellor, AL

Locksmiths recommend changing your locks once every seven years for the best security at your home. Locks can wear out over time, so you should inspect your locks regularly. A higher grade lock provides you with more cycles than those with a lower grade.

Over time, latch components may wear out or get grimy, leading to this problem. First, check for dirt, dust, or debris in the latch mechanism to ensure smooth operation. Use an aerosol duster and lubricant to clean and loosen. You may also need to tighten the screws in the component, adjust the strike plate, or replace the lock. If none of these steps resolve the problem, consult a professional locksmith.

When you take a key to a hardware store or a locksmith for copying, you can expect the key-cutting process to take as little as 30 seconds. The key copier will review your current key to decide on the correct blank. Then, your original key and the blank are inserted into a key duplication machine to cut an exact key copy. When it’s all said and done, you can have a new key in your hand in just a couple of minutes.

Lock bumping is a technique locksmiths use to quickly and quietly open a pin tumbler lock, typically found in most types of deadbolts. It involves inserting a specially crafted key, or bump key, into the lock and tapping or "bumping" it with a mallet or similar tool. The force applied causes the lock's pins to jump momentarily, allowing the lock to be turned and opened. Unfortunately, thieves also use this technique to break into homes. Luckily, products like a deadbolt strap will fortify your lock.