Get matched with top pressure washers in Utqiagvik, AK

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

Though bleach is a great way to kill mold and mildew around the house, you should never, under any circumstances, use bleach in a power washer. Bleach is a potent chemical that will destroy the pressure washer from the inside out. If you’re worried about killing mold and mildew, you should instead hire a pro who will use a safe but effective cleaning agent when pressure washing your home.

Generally 1-2 hours, depending on the area and level of dirt accumulation.

Yes, acid washing can change the appearance of the original brick stain color. It removes dirt, and efflorescence, often revealing the brick's original color and restoring its natural beauty. However, if not done carefully, it can also cause slight variations in color due to the cleaning process.