Get matched with top electricians in Bethel, AK

Before hiring an electrician, check out the contractor’s official website, read reviews, and look them up on your local Department of Labor’s website. If you’re hiring for a complex job, pay special attention to their level of expertise. Also, call up pros directly to ask about their insurance status, specifically liability insurance, and request customer references.

The main reason outlets become loose is because the contact points have started to wear down after years of use. Occasionally, poor wiring can cause heat or sparks that can damage the outlet and cause it to become loose. Either way, if your plugs slide out after being inserted into the outlet, it’s time to replace it.

A water heater is one of the heaviest hitters in your home, and it needs as much power as possible to help it run efficiently and effectively.

Your water heater should be on its own dedicated circuit breaker, with no other power sources running to it. This is required to meet the National Electric Code–and to ensure it runs as efficiently as possible.

In most cases, line wires are located at the bottom of a panel or device, while load wires are located at the top. Line wires are generally black, while load wires are typically red or black. To tell for sure, you can use a multimeter or volt pen to test the wire. A live or line wire will always carry a charge, while a load wire will only carry a charge when it’s in use.