Best flooring contractors near Wolfforth, TX

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

While it may not always be ideal, you can fix a squeaky floorboard without removing the carpet. Pros use specialized carpet screws and drive them through the carpet into the subfloor, securing floorboards. They may also use nails instead of screws if they suspect the pile will get caught in the screw. While some types of carpet will hide the screws and nails, a low-pile carpet may not.

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.

The relative cost of adding an epoxy coating to your garage varies compared to other flooring materials and the type of epoxy. For example, epoxy can cost between $3 to $12 per square foot to install, which typically costs more than other garage flooring options, such as concrete sealers, vinyl, and concrete stain. In comparison, vinyl SPC flooring for garages cost between $3.50 to $8 per square foot and concrete sealer costs $50 to $420, depending on the type of sealant.