Get matched with top pressure washers in New Deal, TX

Does the water in your taps sometimes come out very slowly? If so, you might have problems with low water pressure in your house, and your pressure washer won’t effectively clean. To test if your water pressure is sufficient, time how long it takes for the water from your hose to fill a 5-gallon bucket. Usually, if it takes less than two minutes, you’re good to go.

It’s always best to check the manufacturer’s instructions for your pressure washer to see what detergents they recommend. If you’re caught short and looking for an at-home solution, you could try using trusty dish soap to help keep your siding sparkling. However, always use a dilute solution, as concentrated dish soap can clog the machine. One tablespoon of dish soap per 1.5 quarts of water is a good place to start.

It takes about 15 minutes per each side of an exterior house to apply detergent and 15 minutes to remove it, so you’ll need roughly two hours for the whole job. However, that length of time may decrease or increase depending on the size of your home, so always budget a little more than expected to ensure you don’t end up rushing to get it done.

Yes, you can pressure wash with just water. The force of the water alone is often enough to remove dirt, grime, and debris from many surfaces. However, for tougher stains like grease, mildew, or algae, adding a detergent or cleaning solution can enhance the cleaning power. Be sure to use the appropriate nozzle and pressure settings for the surface to achieve the best results without causing damage.