Top-rated welders.

Get matched with top welders in Kimball, TN

Enter your zip and get matched with up to 5 pros

Need a pro for your welding project in Kimball, TN?

Select your specific project to find the pro for you.

Find Welders in Kimball

Avatar for 423 Mobile Welding & Fabrication
423 Mobile Welding & Fabrication
4.3(
6
)
Metal Stairs and Railings - RepairMetal Structure or Object - Weld or CutWrought Iron Fence - Repair or Weld

Serving Kimball, TN and surrounding areas

In business since 2025

Free estimates

Emergency services offered

"Had a patio glider sofa that was broken on one side that needed to be welded. Did a great job. On the other side had a bar that needed repaired. Was able to drill through the leg and attached new screw. Sofa looked great. Work was done at my house and left no mess. Arrived on time. Was very professional and polite. Would use this company again and will highly recommend ."
attachment repair
Skids steer attachment
Skids steer attachment
Skids steer attachment
Skids steer attachment

+18

Response time3 hrs
...
Showing 1-10 of 51
Welding questions, answered by experts

While a high-speed circular saw will cut through metal, and even cut through multiple sheets at once, the fast-spinning saw blades create a lot of heat. This heat can damage paint and other protective coatings, leading to serious problems like rust over time. The cost to paint a metal roof again to avoid this damage is typically an additional $0.50 to $1 per square foot.

Yes, you can use a saw to cut metal pipes. The best saw to use is a reciprocating saw, but even a fine-tooth hacksaw can get the job done. No matter which saw you use to cut metal pipes, wear protective gear, like work gloves, safety goggles, and ear plugs. Apply a firm, steady pressure to the tool, and always ensure the pipes are secured so they don't move while you make the cuts.

To maintain custom or fabricated metal structures and extend their lifespan and appearance, perform regular cleaning, apply rust prevention treatments, and use protective coatings.

Professional metal fabricators typically charge around $70 per hour, but the total cost of your project will depend on several factors. The largest cost drivers are the size, complexity, and design of the project, as well as the price and type of metal used. A good way to estimate the total cost is to multiply the cost of raw materials by four; typically, one-quarter of the total goes toward materials and three-quarters toward labor. Your geographic location can also influence costs, as labor and material prices vary by region.

Some welding projects, such as repairing pipes or fences, require travel, whereas others, like furniture repair, do not necessarily require the welder to come to you. Travel and overhead factor into the overall cost of your welding project. Some of the most common welding projects include:

  • Metal furniture repair: $35–$100

  • Pipe repair: $200–$1,000

  • Small gates: $550–$750

  • Fencing: $1,200–$1,800

  • Fabricated sheet metal welding: $750–$2,500

The Kimball, TN homeowners’ guide to welding services

From average costs to expert advice, get all the answers you need to get your job done.