Get matched with top pressure washers in Eagle Butte, SD

Even at the lowest setting, there’s always a risk that pressure washing might damage your shower or tub. Never use this technique if there’s pre-existing damage in your shower or tub, like peeling caulk, sealant, or cracked tiles. And skip this method entirely if there are any wood features present.

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

This answer is a bit tricky because experts say both. You should apply your cleaning solution from bottom to top, but rinse from top to bottom to avoid streaking. When it comes to multi-story houses, you’ll want to start at the top floor and work your way down, but follow the above instructions for each level as if it were an independent structure, rather than washing the whole house as one unit.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.