Get matched with top gas log pros in Sangerfield, NY

If your home uses more than one gas appliance, you'll continue to use gas, even outside of the heating season. Your water heater, gas stove and oven, and gas dryer will all use some gas, although typically much less than a furnace. Additionally, those appliances may also have a pilot light that is lit continually, using a small amount even when no one is at home.

While some building codes allow galvanized pipe for natural gas, it shouldn’t be used for propane. Propane can cause the pipe to wear down, leading to dangerous leaks. Instead of galvanized piping for propane, you should consider coated copper, black iron, or corrugated stainless steel tubing (CSST). For underground propane line installation, you can use polyethylene (PE).

The cost to repair a gas leak is $120 to $250 on average, but it could be as costly as $5,000, depending on the leak location and severity. 

For example, if you have drywall covering the source of the leak, you'll need to hire a contractor to replace the removed drywall. In addition, if the leak is underground, you'll need a contractor to excavate the ground to reach the gas line. 

In most cases, yes, it’s safe to light a gas water heater manually, but you should shut the gas off first, open a window, and let the space air out for about 10 minutes. Modern water heaters shut the gas off entirely if the pilot light goes out, but airing out the area beforehand is good practice and will ensure it’s safe to relight your pilot light manually. Just make sure you turn the gas valve to “pilot” before lighting. If the light keeps going out or won’t light at all, call in a professional.