Get matched with top doorbell installation pros in Stanley, NM

Insulating windows without plastic is usually the better method. Outside of simply replacing your windows, you could buy cellular shades, which trap air between the window and the home, add a window film that blocks UV rays and traps heat, or cover your windows with a low-emissivity coating called “low-E.”

On average, insulating an attic costs about $2,500, with a typical range of $1,500 to $3,500. The final price often depends on the attic's size, with costs generally falling between $1 to $3 per square foot. For example, insulating a 1,800-square-foot attic would likely cost between $1,800 and $5,400.

If the project involves removing old insulation, this can add an average of $900 to the total cost, bringing a full removal and reinsulation project to around $3,000.

Several factors influence the overall cost:

• Insulation Type: Prices per square foot vary significantly by material.

• Reflective: $0.50–$1.50

• Blown-in: $1–$4

• Batt: $2–$4

• Loose-fill: $2–$5

• Spray foam: $2–$5

• Structural insulated panels (SIPs): $4–$7

• Project Complexity: Factors like sealing air leaks, poor attic accessibility, and required inspections can add to the cost.

• Removal Issues: The discovery of mold, asbestos, or pests during the removal of old insulation can substantially increase the price.

Ideally, you can add new insulation to your existing insulation. However, some circumstances require you to remove old insulation before adding any new insulation: 

• If the insulation is over 15 years old

• If the insulation is wet or moldy

• If it is vermiculite insulation

• If you see signs of pest infestation

Removing old insulation is best left to a pro who can safely dispose of potential moldy or asbestos-ridden insulation.

Yes, you can install insulation behind drywall yourself, but only if your walls are not finished. If your studs are exposed, installing fiberglass insulation in roll or batt form is very straightforward and just requires a few tools and some safety equipment. If your walls are already finished and you’re looking to add insulation, it’s better to hire a professional, as you’ll likely need blown-in insulation, which can be dangerous to work with and a challenge to get into the proper areas in your wall voids.