Top-rated deck repair pros.

Get matched with top deck repair pros in Pena Blanca, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your deck repair project in Pena Blanca, NM?

Select your specific project to find the pro for you.

Verified Reviews for Deck Repair pros in Pena Blanca, NM

*The Angi rating for Deck Repair companies in Pena Blanca, NM is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Deck Repair needs.

*The HomeAdvisor rating for Deck Repair companies in Pena Blanca, NM is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Deck Repair needs.

Last update on February 27, 2026

Find Deck repair pros in Pena Blanca

Avatar for Keen Remodeling services, LLC
Keen Remodeling services, LLC
5.0(
3
)
Deck or Porch - RepairDeck or Porch - Repair - For Business

Serving Pena Blanca, NM and surrounding areas

In business since 2020

Free estimates

Emergency services offered

"They did a beautiful job, were very respectful men and I would highly recommend them."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+24

Recommended by100%of homeowners
Request Quote
Deck Repair questions, answered by experts

Your deck may look or feel fuzzy after pressure washing because the high-pressure spray tears some wood fibers as it removes the outer layer of dead and discolored wood. This fuzzy effect is a normal part of the pressure-washing process and will go away on its own in a few weeks. You can opt to spot-sand your deck if you’d like to remove it more quickly.

PVC decking tends to be cooler than composite because the material is less dense and absorbs less heat. However, it depends on the deck’s color. A dark-colored PVC deck may run hotter than a light-colored composite deck. If you’re concerned about your deck getting too hot, it’s best to stick to a light color such as beige or gray.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

Yes, you can build a pool deck yourself, but it takes precision, a lot of time, and many specific tools. You’ll need to create a deck plan, be careful with measurements, cut each piece of wood, secure the pieces properly, and ensure the deck meets building codes. Building a deck around a pool is a rewarding DIY, but it’s time- and labor-intensive, so thoughtfully consider your abilities and the time you have before embarking on this DIY.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

The Pena Blanca, NM homeowners’ guide to deck repair services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles