Top-rated deck cleaning pros.

Best deck cleaning pros near Eunice, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Eunice, NM?

Select your specific project to find the pro for you.

Top-Rated Deck cleaning pros in Eunice - Updated Nov 2026

2 Daughters Painting & Handyman
5.0(
4
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Eunice, NM and surrounding areas

In business since 1990

Free estimates

Emergency services offered

"Very friendly, good spirited man. Did a marvelous job with putting up moister barrier, cement boards and tiles. Very respectful towards house an customer.Very satisfied with the work Joey and his partner performed!!"
Recommended by100%of homeowners
LS Solutions
3.7(
8
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Eunice, NM and surrounding areas

In business since 2016

Free estimates

Emergency services offered

"Leon is the best!! In my six years of property management I've never seen an apartment so dirty and demolished. Leon came the next day and worked endlessly until the job was done. Him and his team were very polite and friendly. (Despite the horror inside) They took out all of the trash, broken fixtures, and even the carpet. And then cleaned the whole apartment!! I would recommend his company to anyone."
After An Hour Of Starting
Hallway
:/
Kitchen
Master

+20

Response time12 hrs
Recommended by83%of homeowners
Showing 1-10 of 28
Deck Cleaning FAQs, answered by experts

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Whether you need a permit depends on the deck design and local regulations. Most areas mandate a building permit if the deck is over a specific height or if it's attached to a pre-existing structure. Shorter, freestanding decks may not require a permit, but you should check with local zoning ordinances and your homeowners association for specifics.

You can add a roof to most decks, but you need to have it inspected first. If your deck didn’t come with a roof initially, it may not be able to handle the weight without some structural changes. You can add additional supports to your existing deck to safely add a roof, and tying your deck’s roof to an exterior wall can help add some structural stability, but remember these aren’t DIY projects and need to be left to a pro. 

It depends on the type of wood. The average cost to build a deck out of pressure-treated lumber is $15 to $25 per square foot, but more affordable varieties such as bamboo and cedar cost less at around $3 to $10 per square foot. However, when comparing the cost of vinyl decking versus wood decking, it’s important to also consider ongoing maintenance costs. For example, most woods require regular sealing to keep them protected against weather and rot.

The most likely causes of a deck leaning to one side are damaged deck posts, soil erosion, and inadequate deck footings. If you’re not sure about the exact cause, the best option is to call a contractor who can build a deck to inspect the damage and recommend the best way forward.

The Eunice, NM homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.