Get matched with top woodworkers in Cerro, NM

If you don’t have a coping saw, you can use an angle grinder to cope crown molding, but it takes a little more precision. Place your molding down on your workbench, angle the grinder at a 45-degree angle toward the molding, and back cut the wood. You’ll need to carefully angle your grinder to accommodate the curves in the wood, and aim to remove around 1 inch from the profile of the molding.

Whether or not it’s easier to cut wood when it’s wet versus dry depends largely on the type of tool you use and the wood you’re cutting. For example, a chain saw should still be able to cut through wet wood with relative ease, but it may be more difficult to maneuver due to the wood fibers sticking to the chains of the saw. 

However, you might want to avoid cutting wood entirely when it’s wet if you’re pruning your tree. Sawing a wet tree that you don’t plan on removing can also encourage bacterial and fungal growth and decay.

Wooden soffits, when properly cared for, can last between 10 and 25 years, depending on the type of wood and the climate you live in. Certain wood types will last longer than others, and you might want to consider the cost of replacing soffits when you break down the total project cost. While an initially higher-priced material might seem counterintuitive, it can make more financial sense if you don’t plan on moving. 

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.