Get matched with top stone countertop pros in Millstone, NJ

A minimum overhang of 10 to 12 inches is generally recommended for countertop or island seating to provide enough legroom. For increased comfort, an overhang of 15 to 18 inches is ideal, allowing for more space and a relaxed experience. However, a 10-inch overhang can be sufficient in certain situations, such as for bar-height countertops, when using small stools, or in smaller kitchens where space is limited. Taller countertops may also require less overhang than shorter ones. Ultimately, you should consider your specific needs for legroom and measure to ensure the overhang fits comfortably within your kitchen's layout.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Yes, but you will need the proper gas or electric lines running to the island. You will also need to factor in the costs of a range hood, also known as an extractor. There are several styles to choose from. An island extractor is a chimney-style range hood that hangs from the ceiling directly above your cooktop. A ceiling extractor fits flush into your ceiling above your cooktop, so it is less noticeable and allows for island extensions, such as hanging pot racks. 

For a completely unobtrusive hood, you can choose a downdraft extractor. It is built into the island and can be raised when needed. Its downside is that it takes up space in the island’s cabinets. A venting cooktop is built into the cooktop, and it too takes up cabinet space.

Yes, Corian® and other solid surface materials can be cut with standard woodworking tools, such as a circular saw or a jigsaw. However, it is crucial to use the correct type of blade to avoid damaging the material.

For a circular saw, a tungsten carbide-tipped blade is required; a triple chip grind blade is highly recommended. For a jigsaw, you should use a fine-tooth down-cutting blade. Do not use blades designed for cutting wood, as they can cause microfractures that weaken the edges of the countertop. A diamond blade is also unnecessary, as those are designed for harder materials like natural stone, which Corian is not.

After cutting, the edge will be rough. It is essential to sand and smooth the cut edge to prevent microfractures, which can eventually compromise the integrity of the countertop.