Top-rated well and pump technicians.

Get matched with top well and pump technicians in Devils Lake, ND

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Devils Lake, ND?

Select your specific project to find the pro for you.

Verified Reviews for Well And Pump Service pros in Devils Lake, ND

*The Angi rating for Well And Pump Service companies in Devils Lake, ND is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

*The HomeAdvisor rating for Well And Pump Service companies in Devils Lake, ND is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

Last update on September 01, 2026

Find Well and pump technicians in Devils Lake

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Devils Lake, ND and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Request Quote
Wells and Pumps questions, answered by experts

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

DIY is not recommended due to safety and technical requirements. Hire professionals for accurate diagnosis and repair.

The cost to fix low water pressure heavily depends on the cause of the problem. In some cases, all you need to do is open a valve, which won't cost you anything. However, plumbing repairs cost an average of $325, so if you have a broken pipe or other plumbing problems, you might pay something close to that figure, or more, depending on the issue.

No. Well pump replacement is not recommended as a DIY project, particularly if you have a deep well and a submersible pump. Plumbing and electricity are best left to the pros, especially when something like your well pump includes both. Even when troubleshooting your pump, it pays to have a partner standing by for your assistance and safety.

Common problems include low water pressure, no water, and strange noises. Regular maintenance prevents many issues.

The Devils Lake, ND homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles