Best woodworkers near Whitakers, NC

Hiring a woodworker can be expensive, depending on the job, but it’s very often well worth the investment. Woodworkers are able to provide custom pieces of furniture and handmade construction to present a finished product that is exactly to your specifications. If you have a specific vision for a one-of-a-kind piece of furniture or home feature, the cost of hiring a professional woodworker is worthwhile. Plus, you’ll often get a higher quality product than what you could buy in stores for a fraction of the price.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Labor plays a significant role in the installation of butcher block countertops. Depending on who you hire, your location, the customization level of the project, and whether the wood is already finished, you may pay a professional between $10 and $150 per square foot to install a butcher block countertop. On average, expect the per-hour price to run between $60 and $100.

If you don’t have a power saw with a blade where you can adjust the angle, you could use a miter box and hand saw to make the cuts. The miter box contains wide slots to support the piece of baseboard and other narrow slots to accommodate the blade of the hand saw. However, it’s tough to make non-standard cuts beyond 30 or 45 degrees when using a miter box.