Best stone countertop pros near Walkerville, MT

Granite is heavier than quartz, since it has a higher density. Quartz is made up of engineered stone, which is why it tends to weigh less than granite. Most granite countertops are ¾-inch thick and weigh about 13 pounds per square foot.

The best tool for cutting countertops depends on the type of countertop material. For some softer materials, like laminate (Formica) and butcher block, you can use a hand saw, but most experts recommend power saws like circular saws, since these make the job go faster and easier and give more even results. However, power saws and circular saws are dangerous if used incorrectly, and they can be so powerful that they damage or chip laminate, stone, and other types of countertops. For this reason, you should take safety precautions and use best practices to prevent damage.

Porcelain is a relatively affordable, mid-range countertop material. It typically costs between $50 to $70 per square foot.

Compared to quartz, porcelain is slightly more affordable, as quartz generally ranges from $50 to $200 per square foot. However, lower-quality, builder's grade quartz can be similar in price to porcelain.

Compared to granite, the price can be similar, depending on the quality of the stone. While granite slabs can range from $50 to $200 per square foot, you can find lower-end granite in the same price range as porcelain. High-end granites will cost significantly more.

Porcelain is generally more expensive than laminate, acrylic, and ceramic, but less expensive than high-end slate, concrete, and marble. A key benefit is that porcelain does not require sealing, which reduces long-term maintenance costs.

Yes, Corian® and other solid surface materials can be cut with standard woodworking tools, such as a circular saw or a jigsaw. However, it is crucial to use the correct type of blade to avoid damaging the material.

For a circular saw, a tungsten carbide-tipped blade is required; a triple chip grind blade is highly recommended. For a jigsaw, you should use a fine-tooth down-cutting blade. Do not use blades designed for cutting wood, as they can cause microfractures that weaken the edges of the countertop. A diamond blade is also unnecessary, as those are designed for harder materials like natural stone, which Corian is not.

After cutting, the edge will be rough. It is essential to sand and smooth the cut edge to prevent microfractures, which can eventually compromise the integrity of the countertop.