Marble countertops cost $3,000 on average, ranging from about $2,000 to $5,000, depending on the type of marble, square footage, location, and whether you use tiles or slabs. Another major cost factor to consider is the grading of the marble, which determines its quality level.

Use this grading system when selecting marble for countertops:

• Grade A: Nearly perfect with subtle veining

• Grade B: Minor flaws such as pits, fissures, or blotches

• Grade C: Minor and major flaws like chipping and cracks requiring repair

• Grade D: Significant damage needing repair, with dark veining and pronounced colors

Solid surface countertops are fairly resilient. You can use soapy water or ammonia-based cleaners. You can also occasionally use diluted bleach (around 5 tablespoons per gallon of water) for sanitization. Avoid window cleaners because they leave a waxy film that can dull the countertop’s surface. Solid surface material is nonporous, so there’s no need for sealing.

Rubbing alcohol won’t damage most countertops, and you can mix it with water to create a disinfecting spray to keep your kitchen clean. It’s safer than using bleach on countertops, which can stain and cause discoloration. Be careful with rubbing alcohol when it comes to lacquered or varnished surfaces, though.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.