Get matched with top mailbox repairers in Wesson, MS

Fixing a drawer that is sticky, askew, or broken depends on the specific problem. Start by removing the drawer and examining the slides and tracks for any damage, bent parts, or loose hardware.

For minor issues:

• Clean and Lubricate: If the slides are just sticky, clean them and the corresponding tracks with a hot, damp cloth. Then, apply a lubricant like silicone spray or bar soap to help them glide smoothly. Also, check any roller wheels for problems.

• Tighten Screws: Tighten any loose screws on the slides and tracks. If screw holes are stripped, you may need to fill them and re-drill.

For more significant damage:

• Bent Hardware: If a slide is bent, you may be able to remove it, straighten it out, and reinstall it.

• Broken Parts: If a slide or track is broken or severely damaged, it will need to be replaced. Unscrew the damaged part and install a replacement that matches the type and size of the original.

After performing the repair, reinsert the drawer and test it to ensure it opens and closes smoothly, making any final adjustments for proper alignment. It can also be helpful to consult the manufacturer's guidelines for your specific drawer system.

Yes, there are several wood filler products on the market that look like wood. Your best bet is to take a cabinet door to your local hardware store to match the appropriate wood filler to your door. Some brands make filler that is masked to look like wood and can also be sanded, cut, stained, and painted. 

Whether the leather repair is worth it depends on the extent of the damage, the cost to repair, and the value of the leather item. If the leather is part of an item that’s very expensive to replace, then attempting to repair it may be worth it. Also, if the leather piece holds great sentimental value, it’s worth restoration or repair, if possible.

Yes, you can fill rotten wood with expanding foam. You may prefer using an expanding foam treatment instead of wood filler since the latter can take a long time to dry. It may also provide an easier solution when you’re dealing with smaller gaps. If you use expanding foam, allow it to cure for about 24 hours before you sand and prime it.