Get matched with top asphalt driveway pros in Isola, MS

Building a road on a slope requires careful planning and will normally require a drainage system underneath to prevent flooding and damage to the road over time. Your professional may lengthen your road to create switchbacks if the slope directly to your home is too steep, as there are regulations for maximum road slope. The drainage system will help prevent runoff from the higher side of the slope from damaging the asphalt or concrete. Keep in mind that building a road on a slope isn’t a good DIY project, as a lot can go wrong.

There are quite a few differences between concrete and asphalt. Concrete is more costly up front and more challenging to repair. Asphalt does better in cold climates and works well with radiant heat systems. Porous asphalt is also excellent for wet climates, as it allows the water to drain away. However, it does get unpleasantly hot in the summer and requires more maintenance than concrete.

The main difference between asphalt and blacktop is that asphalt has a lower ratio of bitumen—a low-grade tar-like crude oil—than blacktop. While blacktop is heated to 300 degrees or more, hot-mix asphalt is heated to a lower temperature, typically between 275 and 300 degrees Fahrenheit. Consult an asphalt driveway professional about which type of material is the best fit for your future asphalt driveway.

Overall, a paver driveway is considered the easiest to maintain because homeowners are able to do driveway repair one piece at a time without impacting the rest of the driveway. Unlike paved options, paver driveways contain individual stones that aren't physically connected. By comparison, you may need to reseal or redo a full asphalt driveway if just one portion sustains a significant crack.