Get matched with top deck maintenance specialists in Gulf Hills, MS

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.

While the terms deck and porch are often used interchangeably, they are two distinct structures. A porch is a covered structure, usually attached to the front of a home, that offers protection from the elements. In contrast, a deck is an open, uncovered platform, often attached to the back or side of a home. Because porches have a roof, they typically require less maintenance than decks, but both features need regular cleaning and repairs to stay in good condition.

Yes, snow should be removed from a deck to protect it from damage caused by moisture and heavy loads. Shovel the snow off of your deck regularly once it is more than four inches deep. Avoid using salt, which can damage your deck.

The best and fastest way to remove paint from a deck often involves combining a chemical stripper with a pressure washer. Gel-based paint strippers are highly recommended because their thick consistency makes them less messy and easier to apply than liquid strippers. After applying the stripper to loosen the paint, you can use a pressure washer to efficiently wash away the residue. When using a pressure washer for this task, it's important to use a low pressure (under 1000 PSI) to avoid forcing too much moisture into the wood, which could lead to mildew or rot.