Get matched with top stucco pros in Stanberry, MO

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

A standard drill will work just fine if you’re drilling small holes, and only a few of them. But anything with a diameter larger than 3/8 inch is best done with a hammer drill, since it is stronger, faster, and also makes your drill bits last longer. While you don’t absolutely need a hammer drill for stucco, it is a worthy investment if you think you might drill more holes down the road.

Solid, unpainted stucco shouldn’t suffer damage from dots of glue used for this task. If the stucco is dirty, you may notice slight marks when you heat and peel the glue away, but these aren’t permanent.

However, not all stucco walls are solid stucco. Some are “faux” stucco with a foam backing. This kind of stucco veneer is more susceptible to damage, including damage from hot glue. We don’t suggest attaching anything to these kinds of stucco walls, so make sure you check the stucco type before starting this project.

Homeowners insurance generally won’t cover stucco damage unless it’s caused by a covered event like a storm or fire. You’ll need to pay out of pocket for damage caused by age, wear and tear, lack of maintenance, or faulty installation. Consult your policy for the specifics of what stucco damage is covered and what isn’t.