Top-rated well and pump technicians.

Best well and pump technicians near Kennett, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Kennett, MO?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Kennett - Updated Nov 2026

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Kennett, MO and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,689
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Kennett, MO and surrounding areas

In business since 1971

Credit card accepted

"Rather than fix the issue the first 2 calls, more refrigerant was pumped into the system. This cost me $75 for each call plus the cost of the refrigerant. The 3rd time, they fixed a valve and refilled the refrigerant and I am monitoring to see if this really fixed the problem. So I am out $225 for service calls fro the same problem and the cost of the refrigerant. I think they take this approach intentionally."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Mullins Plumbing
New to Angi
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Kennett, MO and surrounding areas

In business since 2019

Free estimates

Credit card accepted

Mullins Plumbing is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests and make their concerns the basis of our business. \n

Wells and Pumps FAQs, answered by experts

If you’re going away on vacation or leaving your home for a long time, it’s a good idea to switch off your well pump and pressure tank before you go. This way you can prevent any damage from unexpected leaks that may occur or unforeseen electrical issues while you’re away.

Well pumps need power to run, so they can’t function without electricity. If your power shuts off, there can sometimes be enough pressure in the water tank to allow for a lucky flush or a bit of tap water—but this won’t last long. It’s a good idea to have a backup generator or an alternative power source like solar if you’re worried about losing power.

No, a larger well pressure tank will not increase your home's water pressure by itself. Water pressure is determined by the pressure control switch on the well pump.

However, a larger tank does offer other benefits. It can store more water, which allows you to run water for longer periods before the pump needs to turn on. This reduces how often the pump cycles on and off, leading to less wear and tear on the pump and the entire well system. Consequently, a larger tank can help extend the life of your equipment and may prevent future pump issues that could affect water pressure.

If your goal is to increase water pressure, consider these alternatives:

  • Adjust the pressure settings on your tank to a higher PSI (pounds per square inch).

  • Replace your current pump with a model that has a higher flow rate, measured in gallons per minute (GPM).

  • Have a professional install a water pressure booster pump in your plumbing system.

  • If you experience pressure fluctuations, consider upgrading to a constant pressure system.

Servicing includes cleaning filters and coils, checking coolant levels, and inspecting electrical connections.

If you have a self-cleaning washing machine but you’re still seeing lint, your water pump filter might be clogged. To clean it, you should unscrew the drain hose, then remove the water pump filter. From there, you can inspect it and clean it with warm water before replacing it. Check to be sure your washing machine is functioning by running a short cycle. 

The Kennett, MO homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.