Get matched with top brush chipping pros in Fair Play, MO

Unless you plan to use a dump trailer for business purposes, it will be hard to justify the cost of buying one. Even a small, used 6-by-10-foot model could set you back as much as $5,000, and larger, high-quality models can cost up to $15,000 to buy brand-new.

To remove a shrub, start by cutting back the shrub using pruning shears, loppers, or a chainsaw. Next, dig around the base of the shrub with a pointed shovel to expose its root system. Then, use a shovel or a mattock to loosen the roots, making it easier to pull or lift the shrub from the ground. For larger shrubs or stubborn root systems, attaching a chain or strap to the base and using a vehicle to pull it out can be effective. Ensure proper disposal of the shrub and its debris following local waste disposal guidelines.

The most common alternative is burning the stump first, then dealing with the cinders and ashes. As you can imagine, this option creates fire hazards, especially since roots can burn underground, hidden, for long afterward. That’s why many states and cities have outlawed the use of stump burning entirely. We do not recommend this option as a viable alternative unless you get a permit from the local fire department and practice all safe burning procedures.

Others prefer a more long-term DIY approach of degrading the stump with home mixtures like Epsom salt and vinegar injected directly into it. This may help the stump decay faster, allowing homeowners to dig it out themselves, but it’s still a lengthy process. It usually takes months for a stump to start falling apart with such treatments, and in the meantime, it can be vulnerable to rot, insects, and other problems.

Depending on the method you choose to remove grass, it may or may not matter whether the grass is wet or dry when you perform the task. A dryer lawn will be easier to negotiate with a sod cutter, especially if you're not planning to reuse the turf. However, using a shovel by hand might be a little easier if the ground is slightly damp but not so much that it sticks to the tool.