Get matched with top pool table assembly pros in Ivanhoe, MN

Yes, you should keep your pool pump running when adding salt, and leave it running for 24 to 48 hours. This will help circulate the salt to ensure even distribution. You will want to turn off your pool’s salt chlorine generator before adding salt and leave it off until it fully dissolves. Check your manufacturer’s instructions for steps specific to your saltwater pool maintenance.

Whether or not a pool needs a dedicated circuit depends on the electrical needs of the motor, lights, and pump. Keep in mind that pool motors can use a lot of electricity. A dedicated circuit can prevent the breaker from tripping whenever you use the pool. A small motor for an equally small pool may only need a GFCI outlet. It’s best to plug it directly into the outlet rather than using an extension cord. You should also consult an electrician to ensure your pool’s electrical system is in accordance with local regulations.

The formula you’ll use to measure your pool will differ based on the shape of your pool. For a rectangular pool, you’ll use the following formula to find the size in gallons: length x width x depth x 7.5. If the depth changes from one end of your pool to the other, take the average by finding the depth at the deepest and most shallow points and dividing that number by two. Circular and oval pools require different, more complicated formulas, which can be found in this article.

You don’t need to drain the whole pool to patch a pool liner, but be prepared to dive in with your swimsuit and goggles to patch a leak below the water level. By draining the pool, you can actually expose the liner to more harsh conditions, like wind and sunlight, that cause the tears to worsen. It’s best to use the ink test and waterproof patches or tape to identify the leak and patch it up.